AQUAPHOR S550 WHOLE HOUSE WATER PURIFICATION SYSTEM

MODEL AQUAPHOR S550

Maximum compensated hardness – 1 200 mg/l
Maximum iron concentration 10 mg/l
Manganese concentration – 1 mg/l
Minimum pH – 6
Minimum and maximum water and ambient temperature – °C 5°-38°
Water pressure minimum/maximum – 1.4-7 bar
Maximum flow rate to the drain during regeneration, 9.1 L/min**
Nominal/maximum capacity – 23/35 l/min (1.38/2.1 m3/h)
Pressure drop at a flow rate of 22.7 l/min – 1 bar***
Capacity in HE mode, kg salt/hardness grams 0.8 / 465
Capacity in HC mode, kg salt/hardness grams 2.1 / 903
Maximum capacity in AU mode, kg salt/hardness grams 3.3 / 1 100
Regeneration – intelligent, based on water content
Power supply – 12V AC; 50/60 Hz; 0.015 kW/h
Plumbing connections – 1″ OD
Minimum drainage pipe diameter – 16 mm, 5/8 in.
Resin reservoir size – 26.7 x 27.7 cm
Height – 55.4 cm
Base area, 32.2 x 43.2 cm
Gross weight ~ 35 kg
Fine-grained, chlorine-resistant resin – 15 l
Washing capacity, l/min 1.9

** The flow rate must be checked at the end of the discharge line.
*** It is important to consider performance and pressure drop. If the filter is used for a long time at high flow rates (close to the maximum flow rate of 30/35 l/min), the cleaning efficiency may decrease.

An ultra-compact, versatile, cost-effective and reliable two-in-one water filtration system for softening and iron removal. Suitable for primary filtration of iron (concentrations up to 10 mg/l), solid salts and particles up to 20 microns in diameter.

The AQUAPHOR S550 is a very good solution for cleaning hard water – both at home and in city apartments. It is extremely compact, so no separate utility room is needed, and fits perfectly under the kitchen sink.

“AQUAPHOR water softeners are an advanced alternative to conventional water softeners used at home. This solution is highly efficient, uses little salt and requires a small amount of water for regeneration.