This unit is connected to a sewer and a power supply. Everything you need to install the system is included in the installation kit. No collection vessel is needed, fresh water is supplied immediately by turning off the tap. The high performance, high pressure pump is reliable and efficient. An additional electronic system controls the water treatment process and displays the operating parameters on a colour display. The RO Pad produces pure water and discharges all pollutants to the sewer.
You can drink water straight from the tap – no boiling required!
[ApSC sc_key=”sc2007723923″][/ApSC]
[ApSC sc_key=”sc2007395547″][/ApSC]
[ApSC sc_key=”sc3432219613″][/ApSC]
[ApSC sc_key=”sc3436218356″][/ApSC]
SPECIFICATION
It actually produces about 1.5 litres of water per minute, just like conventional RO systems. The difference is that the RO Pad produces water as soon as you open the faucet. There is no need for a pressurised water collection tank. Another outstanding advantage of this system is the very low rejection flow. The RO Pad produces 1.5 litres of clean water, while discharging only 0.6 litres of waste water.
If you are looking for a modern, small-sized, cost-effective, high-performance unit – the RO Pad is the leader!
TECHNICAL CHARACTERISTICS
Voltage and frequency 220V/60Hz or 110V/60Hz
Power 80W
Pure water flow rate 0.8L/min
Inlet TDS ≤ 2500ppm
Chlorine level ≤ 0.2ppm
Water purification efficiency > 95%
Inlet water pressure (min/max.) 14.5 – 43.5 psi
Inlet water temperature (min/max) 5°C – 45°C
Flow type: automatic
Membrane flushing: automatic
Water faucet WATERLOVERS GF 02C
Dimensions: 43 cm x 10.5 cm x 39.5 cm (H/W/D)
STEPS IN WATER TREATMENT
1. Primary PP filter
2. Carbon block filter
3. Two reverse osmosis membranes with a capacity of 150 GPD each
After changing the filters, the unit must be rebooted.
Reloading instructions
Connect the power supply and hold down the “Reset” button for 5 seconds, the device will start the reboot operation. All symbols will light up and start flashing. Press the “Reset” button briefly to select the cartridge to be reloaded, then press the “Reset” button again. Select the filters from right to left. When the symbol moves towards the filter to be reloaded, press the “Reset” button to reload.
[ApSC sc_key=”sc2405632435″][/ApSC]
[ApSC sc_key=”sc2074007692″][/ApSC]
[ApSC sc_key=”sc1638389514″][/ApSC]
[ApSC sc_key=”sc2565111130″][/ApSC]
[ApSC sc_key=”sc3576171623″][/ApSC]
[ApSC sc_key=”sc2806994910″][/ApSC]
[ApSC sc_key=”sc3374618400″][/ApSC]
[ApSC sc_key=”sc3061424968″][/ApSC]
[ApSC sc_key=”sc2895577841″][/ApSC]
[ApSC sc_key=”sc3300756167″][/ApSC]
