MODEL AQUAPHOR S550 P1
Maximum compensated hydrogen sulphide – 1 mg/l
Maximum compensated hardness – 1 200 mg/l
Maximum iron concentration 10 mg/l
Manganese concentration – 1 mg/l
Minimum pH – 6
Minimum and maximum water and ambient temperature – °C 5°-38°
Water pressure minimum/maximum – 1.4-7 bar
Maximum flow rate to the drain during regeneration, 9.1 L/min**
Nominal/maximum capacity – 23/35 l/min (1.38/2.1 m3/h)
Pressure drop at a flow rate of 22.7 l/min – 1 bar***
Capacity in HE mode, kg salt/hardness grams 0.8 / 465
Capacity in HC mode, kg salt/hardness grams 2.1 / 903
Maximum capacity in AU mode, kg salt/hardness grams 3.3 / 1 100
Regeneration – intelligent, based on water content
Power supply – 12V AC; 50/60 Hz; 0.015 kW/h
Plumbing connections – 1″ OD
Minimum drainage pipe diameter – 16 mm, 5/8 in.
Resin reservoir size – 26.7 x 27.7 cm
Height – 55.4 cm
Base area, 32.2 x 43.2 cm
Gross weight ~ 35 kg
Fine-grained, chlorine-resistant resin – 15 l
Washing capacity, l/min 1.9
** The flow rate must be checked at the end of the discharge line.
*** It is important to consider performance and pressure drop. If the filter is used for a long time at high flow rates (close to the maximum flow rate of 30/35 l/min), the cleaning efficiency may decrease.
The unit model has been supplemented with KDF resin, which eliminates the unpleasant rotten-egg smell of hydrogen sulphide.
An ultra-compact, versatile, cost-effective and reliable three-in-one water filtration system for water softening, iron removal and neutralisation of hydrogen sulphide (rotten egg smell). Suitable for primary filtration of iron (concentrations up to 10 mg/l), solid salts and particles up to 20 microns in diameter.
The AQUAPHOR S550 P1 is a very good solution for cleaning hard water – both at home and in city apartments. It is extremely compact and does not require a separate utility room and fits perfectly under the kitchen sink.
“AQUAPHOR water softeners are an advanced alternative to conventional water softeners used at home. This solution is highly efficient, uses little salt and requires a small amount of water for regeneration.
– Simultaneous removal of iron, hydrogen sulphide, manganese and water hardness
– Efficient operation even at very low tap pressures
– Saves up to 60% salt
The unique tank design and the smallest ion-exchange resin granules in the filler enable the system to operate quietly, quickly and very economically. The amount of salt and water used for regeneration is much lower than with conventional column-type water softening filters.
[ApSC sc_key=”sc3033311905″][/ApSC]
[ApSC sc_key=”sc3432219613″][/ApSC]
